Web Analytics

Setting Up Your Hookah

shisha pipe Settings

shisha pipe Parts from Top to Bottom:
  • Charcoal Screen: Separates the charcoal from the tobacco.
  • Clay Bowl: Holds the shisha
  • Bowl Grommet: Seals the bowl
  • Tray: Catches falling ashes
  • Shaft: Enables the smoke to pass from the bowl to the base.
  • Hose Grommet: Seals the hose
  • Air Valve: Enables smoke release when the base fills to its capacity.
  • Base Grommet: Seals the base.
  • Glass Base: Smoke chamber. Should be filled with about one inch of water to filter the smoke.
  • Hose: Enables you to draw the tasty smoke from the shisha pipe.

    Getting ready to smoke:

    1. Fill your base with water. The water should cover the pole about one inch.
    2. Moisten with a little bit of water the Base Grommet for fitting.
    3. Place your Shaft into the Base and rotate clockwise slowly.
    4. Place firmly the Tray over the Shaft.
    5. Place firmly the Bowl grommet over the Shaft.
    6. Bring together your chosen Tobacco flavor, Tongs and Metal Bowl screen (or foil).
    7. Unpack or loosen the Flavored Tobacco. This will make it easier to load into your shisha pipe and will give you a smoother smoke.
    8. Without overfilling the bowl, lightly place your loosened tobacco into the clay bowl.
    9. Fasten a screen (or foil) over the Bowl.
    10. If you are not using a proper screen and you are using foil, be sure to poke small holes into the Foil with the assistance of the FOIL PINCHER or another small sharp object. Attach your Bowl to the top of the Shaft, by fastening it onto the Bowl Grommet.
    11. Hold a piece of Charcoal WITH YOUR TONGS, light the charcoal and place it on top of the Metal Bowl Screen (or foil).
    12. Puff in to the shisha pipe Hose a few times to wake it up.
    ENJOY!


    NOTE ON TOBACCO
    *The tobacco should never burn. Avoid burning your tobacco by keeping your bowl moist. Keep your bowl moist by using fresh tobacco and by making sure there is adequate water in your base.